SwTPcMP-ID board

My MP-ID board (rev. E) has a parallel I/O port, a programmable interrupt timer, and some other "glue" needed for the system. (details?) It is very long - it plugs into a special slot at the edge of the MP-MBA that connects it to both the SS-50 and SS-30 busses, along with a few extra pins in between.

There are eight jumper blocks on this board, as listed below. The settings in my working system(1) are indicated by an asterisk. Of course, this doesn't guarantee that they are the right settings for anyone else.

  1. NOR * / SLOW PER
  2. 48-56 / 56-64 *
  3. 0 * / 1 / 2 / 3 / 4 / 5 / 6 / 7
  4. 8 / X1 *
  5. 9600 * / 150
  6. 6 / 12 *
  7. EX / INT *
  8. IN / OUT *
(1) That is, it *mostly* works. It has some troubles with its disks. But these are the same jumper settings that it worked fine with, so long ago.
10-Jan-1998
yakowenk@csx.unxc.edu
(remove all "x"s to get a valid address)