Code: 0xFE
Description: Triggers an image recording in the SRV image processing sensor and the image
processing with the activated program. This can take up to several seconds, the image recording
takes place however at once and is confirmed with ,,OK''.
The actual image processing starts
afterwards, the result of which is then announced with a spontaneous message ,,CMD INFO, INFO TRIGGER''.
The actual results are transmitted in further ,,CAMAT RES MEASUREMENT BLOCK'' spontaneous messages. Afterwards, the SRV is not ready again until it has dispatched a concluding ,,CMD INFO, INFO READY'' spontaneous message.
Parameter (master -> slave): None.
Response (slave -> master): The image recording takes place at once and is confirmed with ,,OK'' (0x4F4B).
Note: Only for SRV image processing sensor.