Code: 0x05
Description: The command failed.
Note: All parameters are correct, but the command could nevertheless not be executed. This might for example be the case if the module is in emergency stop mode.
With ,,MOVE POS TIME'', ,,MOVE POS TIME REL'', ,,MOVE POS TIME LOOP'' and ,,MOVE POS TIME REL LOOP'', this message is issued if the parameters are correct, but the positions can not be reached with the specified values in the specified time.
The info message is shown too, when executing any loop mooving command ,,MOVE POS LOOP'', ,,MOVE POS TIME LOOP'', ,,MOVE POS REL LOOP'', ,,MOVE POS TIME REL LOOP'' while the module is by the software limit.