Arrival and Cleaning
Body Panels and Tie Downs
Rear
Front
Doors
Battery Box
Gas Tank
Chassis is nearly watertight at each of the cross-members on the floor. We had to use the shop vac to get the water out.
Note for reassembly: The V-shaped gusset at the intersection of the old and new roll bars (outside, driver's right side) is water tight. This is probably not a Good Thing.
Mounting Brackets for rear body panels (little brackets that go between frame and body panels are in a hardware bag.
Attachment: Driver's Right: modified support to body makes wrench/socket access to bolt head very awkward. Nick undid it a little from underneath, then once part of the bolt cleared the support, he was able to get a better tool on it
The door hinges have two (each side) very long, thin pins through them. They are in a plastic box.
The side pods were lengthened forward of the battery compartment. You can see it in both the top of the pods and on the inside of the pods.
Trim from around 3 sides of battery entry hole is saved. Wingnut and long screw that held battery cover down were removed and bagged.
Miscellaneous: Tie Downs, Battery Box, Fire Bottle, Seat Belts
Hardware for 6? tie downs removed and bagged.
We discarded the rubber matting that was on top of the side pods.
Fire Bottle mount was removed. Mounting hardware is in a bag; bottle mount is in with bottle and the old seatbelts. This bin was NOT delievered to K&E on 7/6/06.