Is the Diagnostics User. If one logs in this user, then a further interface ´
(CAN or PROFIBUS active => RS232 is also opened; RS232 active => CAN will be opened in addition)
will open. Bus traffic on the Primary Interface can be recorded through this or targeted information
can also be called up to a very limited extent. Parameterization of the modules is possible.
 | Please note! No active control of the modules is possible! |
If the Diagnostics User is activated through the primary interface, then a ,,Record'' is active. The command ,,CMD TOGGLE IMPULSE MESSAGE'' can be used to switch the status of the secondary interface from ,,eavesdropping'' to ,,active''. The command must be sent via the secondary interface. Commands can be sent via the secondary interface when in ,,active'' status. If the module is in fault status, then the opportunity exists of registering at the module directly as Diagnostics User via the secondary interface. The status of the secondary interface is then active. With the command ,,CMD TOGGLE IMPULSE MESSAGE'', the status of the secondary interface can be switched from ,,active'' to ,,eavesdropping''.