CHANGE USER (0xE3)

CHANGE USER (0xE3)

Code: 0xE3
Description: The current user of the module is changed.
Parameters (master -> slave):

none
User ,,User'' is set.
Password
for the respective user

Response (slave -> master): ): The command is always acknowledged with ,,OK (0x4F4B)''. A byte indicating the current user is attached (0 = User, 1 = Diag, 2 = Profi, 3 = Advanced).
Example:

D-Len Cmd Param

M->S 0x01 0xE3 <password>

S->M 0x04 0xE3 0x4F 0x4B 0x00 User ,,User'' activated.

Note: If an incorrect password is entered, ,,User'' is set. After a restart of the module, ,,User'' is activated.

	D-Len	Cmd	Param
M->S	0x01	0xE3	<password>
S->M	0x04	0xE3	0x4F 0x4B 0x00	User ,,User'' activated.