First steps
All modules must be connected through a suitable communication system to the PC. The following communication interfaces are currently supported by the software:
- RS232
- CAN: cards from VECTOR-Informatik
- CAN: cards from ,,esd electronic system design gmbh''
- CAN: USB-CAN converter PCAN-USB from PEAK-System Technik GmbH
- CAN: cards from IXXAT Automation GmbH (VCI driver version 3)
- CAN: cards from Softing
- Profibus DPV0: cards from Hilscher GmbH
- Profibus DPV0: Siemens AG CP56xx
The respective card must be first installed. Follow the instructions of the manufacturers. For more details look in the appendix.
Figure 4.1: Selection of communication interface
After the selection (Abb. 4.1) of the communication interface is completed
it is opened automatically. The bus search 
automatically detects all connected and switched on modules. If the option ,,Do not initialize detected modules automatically'' in the preferences is checked, the module initialization works manually 
only.
Figure 4.2: Main window
Apart from the Main window (Abb. 4.2) a separate module window (Abb. 4.3) is available for each module, allowing for the testing of all module functions.
Press F1 to access the help system for additional assistance.
Figure 4.3: Module window