Commands for internal programming

The modules can be operated based on internal process programs instead of external controlThe system also caters for the running of previously stored programs that are transferred through digital inputs and outputs, so that the module is solely controlled through these digital inputs and outputs. To do this, the inputs and outputs must be configured accordingly.

In addition, the module can be controlled with 2 bytes by starting previously programmed complex processes with special commands.

In order to program the modules, the data must be fragmented To program the module, we recommend using the supplied software tool via RS232. Programs are always written as complete sets of instructions. If you wish to modify a section of the program script, it must be read in its entirety, amended and then written again to the module.

(The program data is compressed in the EEPROM and equipped with checksums, so that no changes can be made within the complex data structure.)